Vol. 52 No. 4 December 2021
Deformation and Cyclic Strength Characteristics of Loose and Medium-Dense Clean Sand under Sloping Ground Conditions: Insights from Cyclic Undrained Torsional Shear Tests with Static Shear
G. Chiaro, M. Umar, T. Kiyota, and J. Koseki
ABSTRACT: The effects of liquefaction on sloping ground often include the development of extremely large deformation. Although such phenomenon has been repeatedly observed following major earthquakes, the triggering conditions are not fully understood yet. To provide new insights into this issue, in this paper, results of two series of large-strain undrained cyclic torsional shear tests with initial static shear conducted on loose and medium-dense Toyoura sand specimens (relative density of 25-30% and 44-48%) are presented and analyzed. The post-liquefaction response of Toyoura sand is assessed in terms of failure modes and cyclic resistance up to 50% single amplitude shear strain. It is shown that, depending on the combined magnitude of static and cyclic shear stresses, a sand in sloping ground will likely experience a sudden development of large shear deformation (flow deformation) if initial liquefaction takes place, or a more progressive accumulation of large residual deformation, which yet may bring sand to failure, when the onset of initial liquefaction is not achieved.
KEYWORDS: Flow deformation, Liquefaction, Residual deformation, Shear failure, Simple shear, Sloping ground.
