On Prefabricated Vertical Drain (PVD) and Deep Cement Mixing (DCM) / Stiffened DCM (SDCM) Techniques for Soft Ground Improvement

Geotechnical Engineering Journal of the SEAGS & AGSSEA ISSN 0046-5828

Vol. 49 No.2 June 2018

On Prefabricated Vertical Drain (PVD) and Deep Cement Mixing (DCM) / Stiffened DCM (SDCM) Techniques for Soft Ground Improvement

D. T. Bergado, P. V. Long, P. Jamsawang, C. Na Lampun, and A.S. Balasubramaniam

ABSTRACT: Soft ground improvement techniques have become most practical and popular methods to increase soil strength, soil stiffness and reduce soil compressibility including the soft Bangkok clay. This paper focuses on comparative performances of prefabricated vertical drain (PVD) using surcharge, vacuum and heat preloading as well as the cement-admixed clay of Deep Cement Mixing (DCM) and Stiffened DCM (SDCM) methods. The Vacuum-PVD can increase the horizontal coefficient of consolidation, Ch, resulting in faster rate of settlement at the same magnitudes of settlement compared to Conventional PVD. Several field methods of applying vacuum preloading are also compared. Moreover, the Thermal PVD and Thermal Vacuum PVD can increase further the coefficient of horizontal consolidation, Ch, with the associated reduction of kh/ks values by reducing the drainage retardation effects in the smear zone around the PVD which resulted in faster rates of consolidation and higher magnitudes of settlements. Furthermore, the equivalent smear effect due to non-uniform consolidation is also discussed in addition to the smear due to the mechanical installation of PVDs. In addition, a new kind of reinforced method, namely: Stiffened Deep Cement Mixing (SDCM) pile is introduced to mitigate the problems of the Deep Cement Mixing (DCM) pile due to the low flexural resistance, lack of quality control in the field and, consequently, unexpected failures. The SDCM pile consists of DCM pile reinforced with precast reinforced concrete (RC) core pile. The full scale test embankment on soft clay improved by SDCM and DCM piles was studied. Numerical simulations using the 3D PLAXIS Foundation finite element software have been done to understand the behavior of SDCM and DCM piles. The simulation results indicated that the surface settlements decreased with increasing lengths of the RC core piles, and, at lesser extent, increasing sectional areas of the RC core piles in the SDCM piles. In addition, the lateral movements of the embankment decreased by increasing the lengths (longer than 4 m) and, the sectional areas of the RC core piles in the SDCM piles. The results of the numerical simulations closely agreed with the observed data and successfully verified the parameters affecting the performances and behavior of both SDCM and DCM piles.

KEYWORDS: Ground improvement, PVD, DCM pile, SDCM pile, Soft clay, Laboratory test, Full scale test.